What are the treatment methods for the excavator machine being flooded?

What are the treatment methods for the excavator machine being flooded?

Every year when the rainy season enters, the excavator is blistered more or less. A few friends asked the digging brother to ask where the excavator was flooded and how to repair it. The digging brother summed up the experience of repairing the flooded excavator before, and now I will share it with you.

If there is water in the oil when it is discharged from the engine oil, it contains sediment. The best way to deal with this is to disassemble the engine and repair it (note: you can't use the rotating crankshaft to drain the water from the injector seat to remove the water in the cylinder liner to avoid damage to the cylinder liner assembly).

(1) Disassemble and clean all parts of the engine, and then check it. The result is:

1. The piston ring opening clearance has exceeded 0.80mm, and a new piston ring needs to be replaced;

2. The turbocharger is normal, the oil pump works normally, and it is installed after cleaning;

3. Wash the water channel and the inlet and exhaust pipes with pressurized water and then blow dry with pressurized air;

4. Clean the lubricating oil passage of the engine with pressurized air at the same time;

5. After the valve and valve seat are cleaned, use the valve sand to grind the valve to eliminate the rust generated during the wear scar and flooding.